Construction Hardware

We have access to low cost and high-quality glass fittings from overseas. Glass fittings are used to attach glass to building structural components. Examples are structural glass walls or glass handrail systems.

 

Routel Series

rigid heat combination glass attachment fittings allow for a secure attachment and minimize the deflection of the glass panels.

Fixed Countersunk

Our rigid heat combination glass attachment fittings can be used for a smooth exterior surface when the glass is fabricated with a countersunk hole.

Swivel Countersunk

The heat of the swivel glass attachment can tilt up to 6 degrees in any direction on its ball and socket joint. These are typically used in conditions where the glass will be subject to live loads. The swivel heat fitting also employs combination glass attachment with countersunk hole

Fixed Outer Disk

This same fitting also can be used for the cap type of mounting when using the supplied adaptor washer. This requires just a standard hole in the glass.

Swivel Outer Disk

This same fitting also can be used for the cap type of outer disk. This requires a standard hole in the glass outer surface.

Single Arm Heavy Duty Post Mount Fitting

This single arm fitting is used to attach a single glass panel to a structural end post.

Double Arm Heavy Duty Post Mount Fitting

This double arm fitting is used to attach two inline glass panels to a structural center post.

Double Arm V Heavy Duty Post Mount Fitting.jpg


This post mount fitting is used to attach a single glass panel to a structural end post, or two inline glass panels to a structural center post.

Three Arm Heavy Duty Post Mount Fitting

This three arm fitting is used to attach three inline glass panels to structural center post where they abut to a soffit corner.

Four Arm Heavy Duty Post Mount Fitting

This four arm fitting is used to attach two inline glass panels to a structural center post.

Single Arm Heavy Duty Wall-Fin Mount Fitting

This fitting is used to attach a single glass panel to a wall or structural fin.

Single Arm Heavy Duty Wall Fin Mount Fitting with 45 angle

This fitting is used to attach a single glass panel to a wall or structural glass fin.

Double Arm V Heavy Duty Wall-Fin Mount Fitting

This fitting is used to attach a single glass panel to a wall or structural fin.

Four Arm V Heavy Duty Wall-Fin Mount Fitting

Use this four arm fitting to attach two inline glass panels to a structural center fin.

2 Arm V Heavy Duty Wall

This fitting is used to attach two single glass panel to a wall or structural fin.

Single Arm Heavy Duty Wall and Double Arm V Heavy Duty Wall

This fitting is used Single Arm Heavy Duty Wall and Double Arm “V” Heavy Duty Wall to attach a single glass panel to a wall or structural fin.


Do you have a question? Feel free to contact us and we will get back to you shortly!