Aluminium Extrusion
Stickwall markets two systems for site-built construction, Stickwall 1500 and Stickwall 2500.
Stickwall 1500
Available with back section dimensions of 100mm, 125mm, and 150mm
Pressure plate and cap available
SSG available
Anodized finish in: Clear, Bronze, and Black available
Powder coat paint (AAA2603 or AAMA 2604) available in broad colour range
PVDF (AAMA2605) available in broad colour range
Fully thermally broken with polyamide spacers
SW 1500 – VERTICAL SECTION
SW 1500 – HORIZONTAL SECTION
SW 1500 – SSG VERTICAL SECTION
Stickwall 2500
Stickwall 2500 is designed with a proprietary pressure plate design that does not require attachment with fasteners. Pressure plates and caps are held in place by the wedge gasket. This saves the cost of the fasteners and the labour required to install them. Re-glazing is simplified because there is no need to interfere with the adjoining unit gaskets. Finally heat transfer is reduced because there is no conduction through pressure plate screws.
Available with back section dimensions of 100mm, 125mm, and 150mm
Pressure plate and cap available
SSG available
Anodized finish in: Clear, Bronze, and Black available
Powder coat paint (AAA2603 or AAMA 2604) available in broad colour range
PVDF (AAMA2605) available in broad colour range
Fully thermally broken with polyamide spacers
SW 2500 – VERTICAL SECTION
SW 2500 – HORIZONTAL SECTION
SW 2500 – FLOOR ATTACHMENT SECTION
System Performance:
Air Infiltration: 0.10 m3/hr/m2 at 300 Pa
Water Penetration: Zero at 700 Pa
Structural Deflection: Less than L/175 at 1330 Pa
Thermal U-Value: 1.94 W/K/m2
